2000 Jeep Cherokee Limited, 2D PickupFACTORY OEM SERVICE PROCEDURE

Powertrain Verification Test

NOTE: If Powertrain Control Module (PCM) has been replaced and correct Vehicle Identification Number (VIN) and mileage have not be entered into new PCM, Diagnostic Trouble Codes (DTC) will set in Anti-lock Brake System (ABS), air bag and Sentry Key Immobilizer Module (SKIM). Secret key data must be updated prior to starting vehicle. See PROGRAMMING  .
  1. Ensure all disconnected components are reconnected. Check engine oil for fuel contamination. Change oil and filter if necessary.
  2. Start engine and allow to run until operating temperature is reached. Using scan tool, ensure no DTCs have reset. If any DTCs reset, check for Technical Service Bulletins. If different DTCs set, go to appropriate diagnostic procedure under SYSTEM TESTS  . If no DTCs are set, repair is complete.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.