Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Procedure: Notes
Diagnostic procedures are designed to detect system faults as quickly as possible. Body control computer system diagnostic fault messages are accessed through Data Link Connector (DLC). See Figure . Chrysler's Diagnostic Readout Box (DRB) scan tool or generic scan tool, is used to access information from DLC.
A 1999 diagnostic program cartridge, scan tool, body diagnostics cable, jumper wires and digital volt/ohmmeter will be needed for testing. Proceed to IDENTIFYING VEHICLE EQUIPMENT & SYSTEM PROBLEMS under SYSTEM ID TEST in appropriate BODY CONTROL COMPUTER TESTS article.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.