1996 Jeep Grand Cherokee OrvisFACTORY OEM SERVICE PROCEDURE

Test 9A - No Response From Powertrain Control Module

  1. If engine does not run, see the appropriate TESTS W/O CODES article in the ENGINE PERFORMANCE section. See 4.0L 6-Cylinder, see: TESTS W/O CODES - 4.0L 6-CYL and 5.2L V8, see: TESTS W/O CODES - 5.2L V8 . If engine runs, turn ignition off. Disconnect Powertrain Control Module (PCM). PCM is located at right corner of firewall. Turn ignition on. Connect jumper wire between ground and PCM connector, terminal No. C30 (Violet/Brown wire).
  2. Using scan tool, select BODY, BODY COMPUTER, then SYSTEM TEST. Perform CCD BUS test. If scan tool does not display BUS SHORT TO GROUND, repair open Violet/Brown wire. If scan tool displays BUS SHORT TO GROUND, go to next step.
  3. Move jumper wire to terminal No. C28 (White/Black wire). Perform CCD BUS test. If scan tool does not display BUS SHORT TO GROUND, repair open White/Black wire. If scan tool displays BUS SHORT TO GROUND, replace PCM.
NOTE: For connector terminal ID, see CONNECTOR IDENTIFICATIONΒ  and WIRING DIAGRAMΒ  . After each repair, perform VERIFICATION TEST VER-1.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.