Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Jeep Grand Cherokee OrvisFACTORY OEM SERVICE PROCEDURE
Test VER-3A - Verification Procedure
- Reconnect all previously disconnected connectors. Turn ignition on, engine off. Using scan tool, erase all fault messages. To ensure memory seat module has learned sensor limits, select LEARN SEAT LIMITS and follow scan tool instructions. Go to next step.
- Turn ignition off. Close all doors. Allow Body Control Module (BCM) to time out for about 30 seconds. Turn ignition on. Move power seat to full forward and up position limits. Press memory seat SET button, and then number 1 button. Move power seat to full down and back position limits. Go to next step.
- Press memory seat SET button, and then number 2 button. If power seat does not move to all switch positions, repair as required. If power seat moves to all switch positions, go to next step.
- Select number 1 memory seat switch. Allow seat to stop moving. Select number 2 memory seat switch. If memory seat does not operate properly, perform MEMORY SEAT TEST 1AΒ . If memory seats operate properly, go to next step.
- Turn ignition off. Close all doors. Allow BCM to time out for about 30 seconds. Using scan tool, read memory seat and door module fault messages. If fault messages exist, perform MEMORY SEAT TEST 1AΒ . If fault messages do not exist, test is complete.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
