1996 Jeep Grand Cherokee OrvisFACTORY OEM SERVICE PROCEDURE

Body Control Module

Body Control Module (BCM) is located under left side of dash. See Fig 1 . BCM controls many of the vehicle's electrical functions and features by providing power and ground to a variety of systems. BCM contains a central processing unit and interfaces with other modules in the vehicle on the CCD data bus network.

BCM is the only module that has the capability of providing both "bias" and "termination" on the CCD bus system. See CCD BUS SYSTEM. Systems are monitored by BCM through voltage drops.

Fig 1: Identifying System Components
G95E35307Courtesy of CHRYSLER CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.