Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP1994WRANGLER S, STANDARDLABOR TIMESOTHER VARIANTTRANSMISSIONAUTOMATIC TRANSTRANSMISSION ASSEMBLYREMOVAL & INSTALLATION
1994 Jeep Wrangler S, Standard
Removal & Installation
1994 Jeep Wrangler S, StandardSECTION Removal & Installation
WARNING: This page is about the Wrangler S, Automatic, which is a different variant/trim than selected.
3 SPEED TRANS, TRANS ID - A727, A904, A999, 30RH, 31RH, 32RH, 36RH
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Trans Mfr CD 30RH | 4.8 | 3.7 | C | |
| Combination Procedure: FLYWHEEL: Remove & Replace: | ||||
| Trans Mfr CD 30RH | 0.2 | C | ||
| Combination Procedure: FRONT PUMP BUSHING & SEAL: Remove & Replace: | ||||
| Trans Mfr CD 30RH | 0.6 | 0.3 | B | |
| Combination Procedure: OIL PUMP SEAL: Remove & Replace: | ||||
| Trans Mfr CD 30RH, Front | 0.4 | B | ||
| Combination Procedure: TORQUE CONVERTER: Remove & Replace: | ||||
| Trans Mfr CD 30RH | 0.2 | C | ||
| Combination Procedure: TRANS OIL PUMP: Overhaul Removed: | ||||
| Trans Mfr CD 30RH, Front | 0.5 | B | ||
| Combination Procedure: TRANS OIL PUMP: Remove & Replace: | ||||
| Trans Mfr CD 30RH, Front | 0.2 | B | ||
| Combination Procedure: TRANSMISSION ASSEMBLY: Replace: | ||||
| Trans Mfr CD 30RH | 0.6 | 0.3 | C | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.