Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Jeep Cherokee LimitedFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| Cherokee & Comanche | ||
| Drag Link Sleeve Clamp Bolts | 14 (19) | |
| Lower Control Arm Nuts | 133 (180) | |
| Tie Rod Sleeve Clamp Bolts | 36 (49) | |
| Wheel Lug Nut | 65-90 (88-122) | |
| Wrangler | ||
| Drag Link Sleeve Clamp Bolts | 36 (49) | |
| Spring Bracket "U" Bolt Nut | 90 (122) | |
| Tie Rod Sleeve Clamp Bolts | 14 (19) | |
| Wheel Lug Nut | 65-90 (88-122) | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.