Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Jeep Cherokee LimitedFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | ||
|---|---|---|---|
| Automatic Idle Speed Motor | (1) | ||
| Coolant Temperature Sensor | 21 (28) | ||
| Crankshaft Position Sensor | (1) | ||
| Fuel Rail Bolts | 20 (27) | ||
| Ignition Coil | (1) | ||
| Manifold Absolute Pressure Sensor | (1) | ||
| Manifold Air Temperature Sensor | 20 (27) | ||
| Oxygen (O2) Sensor | 23 (31) | ||
| Power Steering Pressure Switch | (1) | ||
| Throttle Position Sensor | (1) | ||
| Vehicle Speed Sensor | (1) | ||
| INCH Lbs. (N.m) | |||
| Fuel Filter Strap Bolt | 108 (12) | ||
| Single-Board Engine Controller-II | (2) 9 (1) | ||
| Throttle Body Bolts | 108 (12) | ||
|
|||
|
|||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.