Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Jeep Cherokee LimitedFACTORY OEM SERVICE PROCEDURE
Control Units
CONTROL UNITS LOCATION
| Component | Location | |
|---|---|---|
| ABS Module | Under left rear seat. | |
| Chime Module | On top of fuse block. See Figure . | |
| ECAT Module | Behind right side of dash. | |
| Headlight Delay Module | Under dash, next to headlight switch. See Figure . | |
| Intermittent Wiper Module | Under left side of dash, left of steering column. | |
| Keyless Entry Module | Between sun visors. | |
| Security System Module | On bracket, left side of A/C-heater housing. | |
| Single-Board Engine Controller (SBEC) | ||
| 4-Cyl. | Left side of engine bay, on left front fender apron, behind air cleaner. See Figure . | |
| 6-Cyl. | Left side of engine bay, on left front fender apron, behind air cleaner. See Figure . | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.