Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Jeep Cherokee LimitedFACTORY OEM SERVICE PROCEDURE
Circuit Protection Devices
CIRCUIT PROTECTION DEVICES LOCATION
| Component | Location | |
|---|---|---|
| Circuit Breakers | ||
| Trailer Tow | Taped to harness, left rear quarter panel. | |
| Windshield Wipers | In fuse block, under left side of dash. See Figure . | |
| Fuse Block | Under left side of dash. See Figure . | |
| Power Distribution Center | ||
| 4-Cyl. | Right side of engine bay, on right fender apron. See Figure & Figure . | |
| 6-Cyl. | Right side of engine bay, on right fender apron.See Figure & Figure . | |
| Power Distribution Center Relay | On right fender apron. See Figure . | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.