Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Jeep Cherokee LimitedFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| Combination Valve Brake Line Fittings | 13-18 (18-24) |
| Front Speed Sensor Bolt | 11 (15) |
| HCU Brake Line Fittings | 10-12 (14-16) |
| Master Cylinder Brake Line Fittings | 11-13 (15-18) |
| Rear Speed Sensor Bolt | 11 (15) |
| Wheel Lug Nuts | 88 (119) |
| INCH Lbs. (N.m)Β | |
| CAB Mounting Bolts | 75-115 (9-13) |
| "G" Switch Bolt | 17-32 (2-4) |
| HCU Bracket Mounting Bolts | 92-112 (10-13) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
