Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Jeep Cherokee LimitedFACTORY OEM SERVICE PROCEDURE
Test B: One Window Operates
- Remove door panel of inoperative window, probe harness side of unplugged motor connector.
- Measure voltage at motor connector terminal "A", while holding switch in the DOWN position. If battery voltage exists, go to next step. If battery voltage does not exist, repair open between motor and master switch. If additional switch is in circuit (not driver's side motor), perform appropriate switch test. See DRIVERS DOOR POWER WINDOW SWITCH (4-DOOR) or DRIVERS DOOR POWER WINDOW SWITCH (2-DOOR) under COMPONENT TESTS.
- Measure resistance at power window motor connector terminal "B", holding switch in the DOWN position. Resistance should read zero ohms.
- If resistance does not read as zero, repair open back between power window motor and master switch. If additional switch is in circuit (not driver's side motor), perform appropriate switch test.
- If both tests are OK, replace regulator assembly. See DRIVERS DOOR POWER WINDOW SWITCH (4-DOOR) or DRIVERS DOOR POWER WINDOW SWITCH (2-DOOR) under COMPONENT TESTS.
CAUTION:
Maintain DOWN position while meter lead is attached.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
