1992 Jeep Cherokee LimitedFACTORY OEM SERVICE PROCEDURE

Ignition Primary

NOTE: Perform SECONDARY SPARK under IGNITION CHECKS before proceeding with test.
  1. Ensure battery has a minimum of 12.5 volts (9.5 cranking volts) available to operate cranking system. Ensure battery cable connections are clean and tight.
  2. Using an analog voltmeter, backprobe the following wires at the distributor. Touch positive lead to Tan/Yellow wire (Gray/Black wire on Wrangler). Touch negative lead to Black/Blue wire (Brown/Red wire on Wrangler.
  3. Set voltmeter to 15-volt DC scale. Crank engine. If voltmeter needle does not fluctuate between 0-5 volts, check related circuits. If necessary, replace sync pulse generator. If sync pulse generator is okay, but engine does not start, see appropriate TESTS W/CODES article in the ENGINE PERFORMANCE Section and check SBEC-II.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.