1991 Jeep Wrangler SFACTORY OEM SERVICE PROCEDURE

Fuel System Rest Pressure (2.5L & 4.0L)

  1. Relieve fuel pressure. See FUEL PRESSURE RELEASE (2.5L & 4.0L). Connect a 0-60 psi (0-4.2 kg/cm2 ) fuel pressure gauge to the pressure test port fitting on fuel rail. Start engine and note reading on pressure gauge. Shut engine off.
  2. Wait 30 minutes and check fuel pressure. Fuel pressure should be within 20 psi (1.4 kg/cm2 ) of first reading. If pressure is not as indicated, check fuel system for leaks at fuel pressure regulator, fuel pump check valve or fuel injectors.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.