1991 Jeep Cherokee LimitedFACTORY OEM SERVICE PROCEDURE

Wheel Alignment Specifications

WHEEL ALIGNMENT SPECIFICATIONS (CHEROKEE & COMANCHE)

Application Fraction Decimal
Camber (Degrees) 0 ± 1/2 0.0 ± 0.5
Caster (Degrees) 7 1/2 ± 1 7.5 ± 1.0
Toe-In (Inches) 0 ± 1/32 0.0 ± .031
Outside Wheel Turn Angle (1) (Degrees) 32 - 33 32.0 - 33.0
(1) Steering stops are not adjustable.
WHEEL ALIGNMENT SPECIFICATIONS (GRAND WAGONEER)

Application Fraction Decimal
Camber (Degrees) 0 ± 1/2 0.0 ± 0.5
Caster (Degrees) 4 ± 1 4.0 ± 1
Toe-In (Inches) 0 - 3/16 0.0 - .188
Outside Wheel Turn Angle (1) (Degrees) 36 - 37 36.0 - 37.0
(1) Steering stops are not adjustable.
WHEEL ALIGNMENT SPECIFICATIONS (WRANGLER)

Application Fraction Decimal
Camber (Degrees) 0 ± 1/2 0.0 ± 0.5
Caster (Degrees)
Manual Transmission 8 ± 1/2 8.0 ± 0.5
Automatic Transmission 6 1/2 ± 1/2 6.5 ± 0.5
Toe-In (Inches) 0 - 1/32 0.0 - .031
Outside Wheel Turn Angle (1) (Degrees) 32 - 33 32.0 - 33.0
(1) Steering stops are not adjustable.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.