Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1991 Jeep Cherokee LimitedFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| Flexible Coupling Bolt | 17 (23) |
| Steering Wheel Retaining Nut | 45 (61) |
| Support Plate Bolt | 17 (23) |
| INCH Lbs. (N.m)Β | |
| Bearing Housing-To-Lock Housing Screw | 35 (4) |
| Bracket-To-Column Bolt | 124 (14) |
| Column Clamp Stud | 20 (2) |
| Column Clamp Stud Nut | 106 (12) |
| Hazard Switch Screw | 27 (3) |
| Housing Cover Screw | 100 (11) |
| Ignition Switch Screw | 35 (4) |
| Lock Housing-To-Jacket Screw | 90 (10) |
| Shift Tube Support Screw | 60 (7) |
| Steering Column Lower Bracket Bolt | 106 (12) |
| Tilt Release Spring Retaining Screw | 35 (4) |
| Turn Signal Retaining Plate Screw | 27 (3) |
| Upper Bracket Nut | 106 (12) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
