1990 Jeep WagoneerFACTORY OEM SERVICE PROCEDURE

Alignment Specifications

WHEEL ALIGNMENT SPECIFICATIONS (CHEROKEE, COMANCHE & WAGONEER)

Application Fraction Decimal
Camber (Degrees) 0 ± 1/2 (0.0 ± 0.5)
Caster (Degrees) 6 ± 1 (6.0 ± 1.0)
Toe-in (Inches) 0 ± 1/32 (0.0 ± .031)
Toe-out (Inches) 0 ± 1/32 (0.0 ± .031)
Outside Wheel Turn Angle Degrees (1) 32-33 (32.0-33.0)
(1) Steering stops are not adjustable.
WHEEL ALIGNMENT SPECIFICATIONS (GRAND WAGONEER)

Application Fraction Decimal
Camber (Degrees) 0-1/2 (0.0-0.5)
Caster (Degrees) 4-5 (4.0-5.0)
Toe-in
Inches 0-5/32 (0.0-.16)
Degrees 0-11/32 (0.0-.34)
Outside Wheel Turn Angle Degrees (1) 36-37 (36.0-37.0)
(1) Steering stops are not adjustable.
WHEEL ALIGNMENT SPECIFICATIONS (WRANGLER)

Application Fraction Decimal
Camber (Degrees) 0 ± 1/2 (0.0 ± 0.5)
Caster (Degrees)
Manual Transmission 8 ± 1/2 (8.0 ± 0.5)
Automatic Transmission 6 1/2 ± 1/2 (6.5 ± 0.5)
Toe-in (Inches) 0-1/2 (0.0-.031)
Outside Wheel Turn Angle Degrees (1) 32-33 (32.0-33.0)
(1) Steering stops are not adjustable.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.