1989 Jeep Wrangler Laredo, AutomaticFACTORY OEM SERVICE PROCEDURE

Current Flow

  1. Remove positive and negative wire connectors from coil. Connect ammeter between positive terminal of coil and disconnected positive primary wire.
  2. Connect jumper wire from negative terminal to ground. With ignition on, current flow should be approximately 7 amps. Replace ignition coil if current exceeds 7.6 amps.
  3. Connect ammeter to coil positive terminal and remove jumper wire from negative terminal. Connect coil Green wire to negative terminal. Current flow should be approximately 4 amps.
  4. If less than 3.5 amps, check for poor contact at 3-wire and 4-wire connectors or distributor ground screw. If current flow is greater than 5 amps, control unit is defective and must be replaced. Normal current flow with engine running is 2.0-2.4 amps. Replace control unit if not to specification.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.