Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1989 Jeep WagoneerFACTORY OEM SERVICE PROCEDURE
Sync Pulse (Stator) Test
- Without disconnecting distributor connector from distributor, insert positive lead of an analog type voltmeter into Blue wire on connector, and insert negative lead into Gray/White wire of connector.
- Set voltmeter to 15-volt D/C scale. Turn ignition switch to the "ON" position. Voltmeter should show approximately 5.0 volts. If there is no voltage, ensure that both voltmeter leads have good contact with wires.
- If there is still no voltage, remove ECU and check for voltage at pin C-16 and ground with harness connected. If there is still no voltage, perform vehicle test using DRB II. If voltage is present, check continuity between Blue wire at distributor connector and C-16 at ECU.
- If there is no continuity, repair harness as necessary. Check for continuity between Black wire at distributor connector and ground. If there is no continuity, repair harness as necessary.
- While observing voltmeter, crank engine. Voltmeter needle should fluctuate back and forth while engine is cranking. This verifies that stator in distributor is operating properly. If there is no sync pulse, replacement of stator is necessary.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.
