1988 Jeep WagoneerFACTORY OEM SERVICE PROCEDURE

Wide Open Throttle (Wot) Switch

  1. Disconnect wiring harness from WOT switch. Connect ohmmeter leads to switch terminals, and manually open and close the switch. When switch is closed, resistance should be infinite. A low resistance should be indicated at wide open position. Test switch operation several times. Replace WOT switch if defective. Reconnect wiring harness.
  2. With ignition switch "ON", connect voltmeter between pin 6 and pin 7 (ground) of diagnostic connector D2. Voltage should be zero with switch in wide open position and greater than 2 volts in any other position.
  3. If voltage is always zero, test for short circuit to ground in wiring harness or switch. Check for open circuit between pin 8 of ECU connector and the switch connector. Repair or replace wiring harness as necessary.
  4. If voltage is always greater than 2 volts, test for an open wire or connector between the switch and ground. Repair as required.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.