Current Flow

1987 Jeep Wrangler Base, 2.5 HSECTION Current Flow
  1. Remove positive and negative wire connectors from ignition coil. Connect ammeter between positive terminal of coil and disconnected positive primary wire.
  2. Connect jumper wire from negative terminal to good ground. With ignition on, current flow should be approximately 7 amps. Replace ignition coil if current exceeds 7.6 amps.
  3. With ammeter connected to coil positive terminal, remove jumper wire from negative terminal. Connect coil Green wire to negative terminal. Current flow should be approximately 4 amps.
  4. If less than 3.5 amps, check for poor contact at 3-wire and 4-wire connectors or distributor ground screw. If current flow is above 5 amps, the control unit is defective and must be replaced. Normal current flow with engine running is 2.0-2.4 amps. Replace control unit if not to specification.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.