Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Jeep Cherokee LimitedFACTORY OEM SERVICE PROCEDURE
Alignment Specifications
WHEEL ALIGNMENT SPECIFICATIONS
| Application | Specification | |
|---|---|---|
| Cherokee, Comanche & Wagoneer | ||
| Axle Gap (Inches) | N/A | |
| Caster (Degrees) | 7 to 8 | |
| Camber (Degrees) | -1/2 to +1/2 | |
| Toe-in (Inches) | 1/32 in to 1/32 Out | |
| Steering Axis Inclination (Degrees) | N/A | |
| Wrangler | ||
| Axle Gap (Inches) | N/A | |
| Caster (Degrees) | 7 3/4 to 8 1/4 | |
| Camber (Degrees) | -1/2 to +1/2 | |
| Toe-in (Inches) | 1/32 in to 0 Out | |
| Steering Axis Inclination (Degrees) | N/A | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.