Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Jeep Cherokee LimitedFACTORY OEM SERVICE PROCEDURE
Coolant Temperature Sensor
- Disconnect wiring harness from CTS sensor. Test resistance of sensor. If resistance is not 185-100,700 ohms (3400 ohms at 70°F; 1600 ohms at 100°F), replace sensor. With engine warm, resistance should be less than 1000 ohms.
- Connect one ohmmeter lead to sensor connector terminal. Connect other lead, in turn to ECU harness connector terminals 15 and 32. Repair wiring harness if an open circuit is indicated.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.