Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1986 Jeep Cherokee Base, 2D Utility, 2.1 B, RWDFACTORY OEM SERVICE PROCEDURE
Fuel Shutoff Solenoid
- If engine will not start, test for correct supply voltage at fuel shutoff solenoid wire harness connector with ignition on. Voltmeter reading should be at least 8 volts.
- If voltage is correct, remove fuel shutoff solenoid from injection pump. Connect a jumper wire between battery positive terminal and fuel shutoff solenoid connector terminal.
- Connect another jumper wire to battery negative terminal and gently contact shutoff solenoid housing. Solenoid should click. Replace solenoid if necessary.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.