Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1986 Jeep Cherokee Base, 2D Utility, 2.1 B, RWDFACTORY OEM SERVICE PROCEDURE
Diode Trio Test
- Remove diode trio from end frame. Connect an ohmmeter to single connector and to one of the 3 connectors. See Fig 1. Note reading and reverse leads.
- A good diode trio will give a high and low reading. If readings are the same, replace diode trio. Repeat tests between single connector and each of the 3 connectors.
NOTE:
Before replacing diode trio, also check rectifier bridge. Do not use high voltage, such as 110-volt test lamp, when testing diode trio.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.