1984 Jeep Pickup J20FACTORY OEM SERVICE PROCEDURE

Thermal Vacuum Switch

  1. With air cleaner temperature below 40°F (-4°C), disconnect vacuum hoses from TVS and connect vacuum source to large outlet.
  2. Apply vacuum to TVS. Vacuum should be held. If not, replace TVS.
  3. Start engine and warm air cleaner to 55°F (13°C), or above. Vacuum should not be held. If it is held, replace TVS.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.