1984 Jeep Pickup J20FACTORY OEM SERVICE PROCEDURE

EGR Valve: Notes

EGR valve is mounted on machined surface at rear of intake manifold on V8 models, and on side of intake manifold on 6-cylinder models. Exhaust gas is drawn from exhaust crossover passage in V8 engines and from an area near heat riser in 6-cylinder engines. Two types of EGR valves are used: Valve without back pressure sensor and valve with integral back pressure sensor.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.