Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 Jaguar F-Pace BaseFACTORY OEM SERVICE PROCEDURE
Diagnostic Trouble Code Index DTC: Electric Steering Column Lock Control Module (ESCL) (F-Pace)
- Diagnostic Trouble Code Index DTC: Electric Steering Column Lock Control Module (ESCL)
- Description And Operation
- Electric Steering Column Lock Control Module (ESCL)
- Notes
- DTC B100D-16: Column Lock Authorization - Circuit voltage below threshold
- DTC B100D-29: Column Lock Authorization - Signal invalid
- DTC B100D-42: Column Lock Authorization - General memory failure
- DTC B100D-51: Column Lock Authorization - Not programmed
- DTC B100D-62: Column Lock Authorization - Signal compare failure
- DTC B100D-64: Column Lock Authorization - Signal plausibility failure
- DTC B100D-72: Column Lock Authorization - Actuator stuck open
- DTC B100D-73: Column Lock Authorization - Actuator stuck closed
- DTC B100D-77: Column Lock Authorization - Commanded position not reachable
- DTC B100D-92: Column Lock Authorization - Performance or incorrect operation
- DTC B100D-96: Column Lock Authorization - Component internal failure
- DTC U0001-88: High Speed CAN Communication Bus - Bus off
- DTC U3002-81: Vehicle Identification Number - Invalid serial data received
- Electric Steering Column Lock Control Module (ESCL)
- Description And Operation
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
