Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 Jaguar F-Pace BaseFACTORY OEM SERVICE PROCEDURE
DTC P0634-68: Control Module Internal Temperature A Too High - Event information: Action
NOTE:
- This DTC is set when the transfer case control module internal temperature exceeds the maximum threshold.
- This DTC may be induced by prolonged driving on a poor traction surface.
- Check the transfer case control module cooling airflow for obstructions (mud packing, etc). Rectify as necessary
- Check the exhaust system for damage. Rectify as necessary
- Allow the system temperature to return to normal. Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and perform routine - On Demand Self Test. If the fault persists, install a new transfer case control module
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
