Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 Jaguar F-Pace BaseFACTORY OEM SERVICE PROCEDURE
Diagnostic Trouble Code Index DTC: BLINDSPOT Monitoring Control Module (Left/Right) - F-Pace
- Diagnostic Trouble Code Index DTC: Blindspot Monitoring Control Module (Left/Right)
- Description And Operation
- BLINDSPOT Monitoring Control Module (BMCM) - Left/Right
- Notes
- DTC B12DA-01: Blind Spot Warning Indicator - General electrical failure
- DTC U0046-86: Vehicle Communication Bus C - Signal invalid
- DTC U0046-87: Vehicle Communication Bus C - Missing message
- DTC U0046-88: Vehicle Communication Bus C - Bus off
- DTC U0232-87: Lost Communication With Side Obstacle Detection Control Module - Left - Missing message
- DTC U0233-87: Lost Communication With Side Obstacle Detection Control Module - Right - Missing message
- DTC U0300-00: Internal Control Module Software Incompatibility - No sub type information
- DTC U0300-57: Internal Control Module Software Incompatibility - Invalid/incomplete software component
- DTC U0533-86: Invalid Data Received From Side Obstacle Detection Control Module-Left - Signal invalid
- DTC U0534-86: Invalid Data Received From Side Obstacle Detection Control Module-Right - Signal invalid
- DTC U0556-09: Invalid Data Received From Front Display Interface Module - Component failures
- DTC U1A00-88: Private Communication Network - Bus off
- DTC U2100-00: Initial Configuration Not Complete - No sub type information
- DTC U2101-00: Control Module Configuration Incompatible - No sub type information
- DTC U3000-45: Control Module - Program memory failure
- DTC U3000-46: Control Module - Calibration/parameter memory failure
- DTC U3000-49: Control Module - Internal electronic failure
- DTC U3000-56: Control Module - Invalid/incomplete configuration
- DTC U3000-78: Control Module - Alignment or adjustment incorrect
- DTC U3000-97: Control Module - Component or system operation obstructed or blocked
- BLINDSPOT Monitoring Control Module (BMCM) - Left/Right
- Description And Operation
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
