Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJAGUAR2014F-TYPE V8 SREPAIR AND DIAGNOSISQUICK LOOKUPSDTC INDEXDIAGNOSTIC TROUBLE CODE INDEX DTC: POWER STEERING CONTROL MODULE (PSCM) -- F-TYPE/X152
2014 Jaguar F-Type V8 S
Diagnostic Trouble Code Index DTC: Power Steering Control Module (PSCM) -- F-Type/X152
2014 Jaguar F-Type V8 SSECTION Diagnostic Trouble Code Index DTC: Power Steering Control Module (PSCM) -- F-Type/X152
- Diagnostic Trouble Code (DTC) Index DTC: Power Steering Control Module (PSCM)
- Description And Operation
- Power Steering Control Module (PSCM)
- Notes
- B1304-04: Electronic Power Assisted Steering System -System Internal Failures
- B1304-07: Electronic Power Assisted Steering System -Mechanical failures
- B1304-16: Electronic Power Assisted Steering System -Circuit voltage below threshold
- B1304-17: Electronic Power Assisted Steering System -Circuit voltage above threshold
- B1304-1C: Electronic Power Assisted Steering System -Circuit voltage out of range
- B1304-98: Electronic Power Assisted Steering System -Component or system over temperature
- C102D-07: High Friction Inside Power Steering -Mechanical failures
- C200B-01: Steering Shaft Torque Sensor 1 - General electrical failure
- C200B-31: Steering Shaft Torque Sensor 1 - No signal
- C1B00-62: Steering Angle Sensor - Signal Compare Failure
- U0001-81: High Speed CAN Communication Bus - Invalid serial data received
- U0001-82: High Speed CAN Communication Bus - Alive/sequence counter incorrect/not updated
- U0001-87: High Speed CAN Communication Bus - Missing message
- U0001-88: High Speed CAN Communication Bus - Bus off
- U0300-56: Internal Control Module Software Incompatibility - Invalid/incomplete configuration
- U2001-00: Reduced System Function - No Sub Type Information
- U2001-07: Reduced System Function -Mechanical Failures
- U2001-16: Reduced System Function -Circuit Voltage Below Threshold
- U2001-17: Reduced System Function -Circuit Voltage Above Threshold
- U2001-98: Reduced System Function - Component Or System Over Temperature
- U2100-56: Initial Configuration Not Complete -Invalid/incomplete configuration
- U2300-54: Central Configuration -Missing calibration
- U2300-55: Central Configuration - Not configured
- U2300-56: Central Configuration -Invalid/incomplete configuration
- U3001-00: Control Module Improper Shutdown - No sub type information
- Power Steering Control Module (PSCM)
- Description And Operation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.