Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJAGUAR2014F-TYPE V8 SREPAIR AND DIAGNOSISQUICK LOOKUPSDTC INDEXDIAGNOSTIC TROUBLE CODE (DTC) INDEX DTC: DIGITAL RADIO CONTROL MODULE (DRCM) -- F-TYPE/X152
2014 Jaguar F-Type V8 S
Diagnostic Trouble Code (DTC) Index DTC: Digital Radio Control Module (DRCM) -- F-Type/X152
2014 Jaguar F-Type V8 SSECTION Diagnostic Trouble Code (DTC) Index DTC: Digital Radio Control Module (DRCM) -- F-Type/X152
- Diagnostic Trouble Code (DTC) Index DTC: Digital Radio control Module (DRCM)
- Notes
- Description And Operation
- Digital Radio Control Module (DRCM)
- Notes
- B1A56-11: Antenna - Circuit short to ground
- B1A56-12: Antenna - Circuit short to battery
- B1A56-13: Antenna - Circuit open
- B1D55-11: Antenna #2 - Circuit short to ground
- B1D55-12: Antenna #2 - Circuit short to battery
- B1D55-13: Antenna #2 - Circuit open
- U2100-00: Initial Configuration Not Complete - No sub type information
- U2101-00: Control Module Configuration Incompatible - No sub type information
- U3000-46: Control module - Calibration/parameter memory failure
- U3000-49: Control Module - Internal electronic failure
- U3000-98: Control Module - Component or system over temperature
- U3003-62: Battery voltage - Signal compare failure
- Digital Radio Control Module (DRCM)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.