Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Jaguar XK Base, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE
Diagnostic Trouble Code Index DTC: Front Controls/Display Interface Module (FCDIM) -- XK/X150
- Diagnostic Trouble Code Index DTC: Front Controls/Display Interface Module (FCDIM)
- Description And Operation
- Front Controls/Display Interface Module [FCDIM]
- Notes
- DTC U1A01-15: Communication Link - Circuit short to battery or open
- DTC U1A4B-48: Control Module Processor B - Supervision software failure
- DTC U3000-48: Control Module - Supervision software failure
- DTC U3000-4B: Control Module - Over temperature
- DTC U3000-55: Control Module - Not configured
- DTC U3000-87: Control Module - Missing message
- DTC U3000-98: Control Module - Component or system over temperature
- DTC U3003-16: Battery Voltage - Circuit voltage below threshold
- DTC U3003-17: Battery Voltage - Circuit voltage above threshold
- Front Controls/Display Interface Module [FCDIM]
- Description And Operation
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.