Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Jaguar XF 2.0FACTORY OEM SERVICE PROCEDURE
Diagnostic Trouble Code Index DTC: Transfer Case Control Module -- XF/X250
- Diagnostic Trouble Code (DTC) Index DTC: Transfer Case Control Module
- Description And Operation
- DTC Transfer Case Control Module (TCCM)
- DTC B1142-62: Ignition Status 1 - Signal compare failure
- DTC P080A-56: Clutch Position Not Learned - Invalid/incomplete configuration
- DTC P0810-04: Clutch Position Control Error - System internal failures
- DTC P0810-07: Clutch Position Control Error - Mechanical failures
- DTC P0810-56: Clutch Position Control Error - Invalid/incomplete configuration
- DTC P0810-78: Clutch Position Control Error - Alignment or adjustment incorrect
- DTC P170E-92: Clutch Delivered Torque Performance - Performance or incorrect operation
- DTC P173A-64: Clutch Actuator Position Sensor Circuit Range/Performance - Signal plausibility failure
- DTC P175B-00: Transfer Case Clutch Deteriorated - No sub type information
- DTC P175C-00: Transfer Case Fluid Deteriorated - No sub type information
- DTC P215A-62: Vehicle Speed/Wheel Speed Correlation - Signal compare failure
- DTC P2787-98: Clutch Temperature Too High - Component or system over temperature
- DTC U0001-81: High Speed CAN Communication Bus - Invalid serial data received
- DTC U0001-87: High Speed CAN Communication Bus - Missing message
- DTC U0001-88: High Speed CAN Communication Bus - Bus off
- DTC U0300-00: Internal Control Module Software Incompatibility - No sub type information
- DTC U2012-4A: Car Configuration Parameter(s) - Incorrect component installed
- DTC U2100-54: Initial Configuration Not Complete - Missing calibration
- DTC U3000-47: Control Module - Watchdog/safety micro controller failure
- DTC U3000-49: Control Module - Internal electronic failure
- DTC U3000-4B: Control Module - Over temperature
- DTC U3006-13: Control Module Input Power "A" - Circuit open
- DTC U3006-16: Control Module Input Power "A" - Circuit voltage below threshold
- DTC U3006-17: Control Module Input Power "A" - Circuit voltage above threshold
- DTC U3006-62: Control Module Input Power "A" - Signal compare failure
- DTC U3007-13: Control Module Input Power "B" - Circuit open
- DTC U3007-16: Control Module Input Power "B" - Circuit voltage below threshold
- DTC U3007-17: Control Module Input Power "B" - Circuit voltage above threshold
- DTC U3007-62: Control Module Input Power "B" - Signal compare failure
- Description And Operation
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
