Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Jaguar XFRFACTORY OEM SERVICE PROCEDURE
Torque Specifications
CAUTION:
*New Torx bolts must be installed
| ITEM | NM | LB-FT | LB-IN |
|---|---|---|---|
| Transfer case to automatic transmission bolts | 43 | 32 | - |
| Transfer case fluid fill/level plug | 60 | 44 | - |
| Transfer case fluid drain plug | 60 | 44 | - |
| Transfer case crossmember bolts | 48 | 35 | - |
| Transfer case mounting bush bolt | 103 | 76 | - |
| Transfer case damper bolts | 48 | 35 | - |
| * Driveshaft to front output flange Torx bolts: | 40 | 30 | - |
| * Driveshaft to rear output flange Torx bolts: | 75 | 55 | - |
| Transfer case control module (TCCM) bolts | 22 | 16 | - |
| Harness bracket to transfer case crossmember bolt | 24 | 18 | - |
|
CAUTION:
*New Torx bolts must be installed
|
|||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.