Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Jaguar XK8 2D ConvertibleFACTORY OEM SERVICE PROCEDURE
Electronic Engine Controls
- Electronic Engine Controls (4.2L, Vehicles Without: Supercharger)
- Specifications
- Electronic Engine Controls - Description & Operation
- COMPONENT LOCATION SHEET 1 of 2
- COMPONENT LOCATION SHEET 2 of 2
- Introduction
- Ignition Modes
- CONTROL DIAGRAM SHEET 1 of 3
- CONTROL DIAGRAM SHEET 2 of 3
- CONTROL DIAGRAM SHEET 3 of 3
- Components
- Engine Control Module (ECM)
- Crankshaft Position Sensor (CKP)
- Camshaft Position Sensor (CMP)
- Engine Coolant Temperature Sensor (ECT)
- Engine Oil Temperature Sensor
- Oil Pressure Sensor
- Fuel Rail Temperature Sensor
- Diagnostic Monitoring of Tank Leakage (DMTL) - NAS ONLY
- Purge Valve
- Mass Air Flow/Intake Air Temperature Sensor (MAF/IAT)
- Manifold Absolute Pressure Sensor (MAP)
- Knock Sensors
- Electric Throttle
- Accelerator Pedal Position Sensor (APP)
- Stoplamp Switch
- Oxygen Sensors
- Generator
- Fuel Injectors
- Ignition Coils
- Fuel Pump Relay
- Cooling Fan Control
- Variable Valve Control (VVC)
- Exhaust Gas Recirculation (EGR) Valve
- Fuel Pump Driver Module
- Fuel Rail Pressure Sensor
- Central Junction Box
- Secondary Air Injection
- Principles Of Operation
- Electronic Engine Controls - Diagnostic Procedures
- Camshaft Position (CMP) Sensor LH - Removal and Installation
- Camshaft Position (CMP) Sensor RH - Removal and Installation
- Catalyst Monitor Sensor - Removal and Installation
- Crankshaft Position (CKP) Sensor - Removal and Installation
- Engine Control Module (ECM) - Removal and Installation
- Engine Coolant Temperature (ECT) Sensor - Removal and Installation
- Fuel Rail Pressure (FRP) Sensor - Removal and Installation
- Fuel Temperature Sensor - Removal and Installation
- Heated Oxygen Sensor (HO2S) - Removal and Installation
- Knock Sensor (KS) - Removal and Installation
- Manifold Absolute Pressure (MAP) Sensor - Removal and Installation
- Mass Air Flow (MAF) Sensor - Removal and Installation
- Variable Camshaft Timing (VCT) Oil Control Solenoid - Removal and Installation
- Engine Oil Pressure (EOP) Sensor - Removal and Installation
- Oil Temperature Sensor - Removal and Installation
- Brake Pedal Position (BPP) Switch - Removal and Installation
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
