Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Jaguar XJRFACTORY OEM SERVICE PROCEDURE
Climate Control Assembly - Removal and Installation: Installation
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Jaguar XKR, 2006 Jaguar XK8, 2005 Jaguar XKR, 2005 Jaguar XK8, and 2004 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
- Position air conditioning switch control module on radio console and install module securing screws.
- Connect switch control module harness multi-plug.
- Install new harness securing tie strap.
- Position radio and install console securing screws.
- Install center console. Refer to FLOOR CONSOLE - REMOVAL AND INSTALLATION .
- Install 'J' gate surround. Refer to SELECTOR LEVER CABLE AND BRACKET - REMOVAL AND INSTALLATION .
- Connect ground cable to battery terminal and install battery cover. Refer to BATTERY CONNECT - GENERAL PROCEDURES .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.