Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Jaguar XJRFACTORY OEM SERVICE PROCEDURE
Accelerator Cable Adjustment - General Procedures
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Jaguar XKR, 2006 Jaguar XK8, 2005 Jaguar XKR, 2005 Jaguar XK8, and 2004 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools
| Tool Illustration | Tool Name | Tool Number |
|---|---|---|
| Accelerator cable adjustment tool | 310-101 |
NOTE:
Right-hand drive vehicles shown, left-hand drive vehicles similar.
- Make sure the kickdown plunger is fully seated to the retaining stud shoulder.
- Remove the driver side bulkhead cover.
- Open the accelerator pedal position (APP) sensor cover.
- Release the APP sensor cover retaining clip.
- Open the APP sensor cover.
- Tension the accelerator cable.
- Remove the accelerator outer cable retaining clip.
- Tension the accelerator cable
NOTE: Make sure 14 teeth are visible on the outer cable. - Install the accelerator outer cable retaining clip.
- Install the special tool to the APP sensor.
- Using the special tool adjust the accelerator cable.
- Slowly press the accelerator pedal through kickdown to the floor, and hold for five seconds.
- Release the accelerator pedal.
- Make sure the APP sensor cam is at the idle position.
- Remove the special tool.
- Close the APP sensor cover.
- Install the driver side bulkhead cover.
CAUTION:
The accelerator cable must be adjusted by pressing the accelerator pedal. Failure to follow this instruction may result in incorrect cable adjustment.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
