Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Jaguar XJ8 BaseFACTORY OEM SERVICE PROCEDURE
Transmission Selector Lever
- Remove the battery cover and disconnect battery ground cable.
- Remove the shift lever knob. See TRANSMISSION SELECTOR LEVER KNOB .
- Remove the J-gate surround. See SELECTOR LEVER GATE FINISH PANEL .
- Remove the console finisher veneer panel. See FLOOR CONSOLE FINISH PANEL for 2001 or FLOOR CONSOLE FINISH PANEL for 2002-03.
- Remove the center console assembly, see FLOOR CONSOLE for 2001 or FLOOR CONSOLE for 2002-03.
- Remove the selector lever indicator assembly. See SELECTOR LEVER INDICATOR ASSEMBLY .
- Detach the selector cable from the gear shift assembly.
- Remove the inner cable to shift lever nut.
- Slacken the outer cable locknuts.
See Figure.
- Remove the gear shift assembly.
- Remove the four fixings.
- Remove the slide plate.
- Remove the four screws.
- Remove the slide block/shaft assembly.
- Remove the gearshift interlock solenoid actuating lever.
- Remove the actuating lever cover.
- Remove the actuating lever securing nut.
- Remove the shift lever assembly from the housing.
- Remove the washer from the pivot shaft.
- Disassemble the shift mechanism.
- Remove the return spring.
- Remove the pivot shaft nut, washer and pivot shaft.
- Remove the pivot bracket, detent plate and washer.
- Remove the ball and spring.
- Clean all components.
- Reassemble the shift mechanism.
- Apply grease and install the detent ball and spring.
- Apply grease to the pivot bracket and install the bracket, detent plate and washer.
- Install the pivot shaft, washer and nut.
- Apply grease and locate the return spring.
- Fit the shift lever assembly to the housing.
- Apply grease to the lever pivot and install the pivot washer. See Fig 5.
- Install the gearshift interlock solenoid actuating lever.
- Secure the actuating lever nut.
- Fit the actuating lever cover.
- Install the slide block/shaft assembly.
- Clean the slide block and shaft.
- Apply grease to the shaft.
See Fig 3.
- Install the slide plate.
- Install the four slide plate screws. See Fig 2.
- Fit the gear shift assembly.
- Install the four nuts. See Fig 1.
- Assemble the cable to the gear shift assembly.
- Locate the outer cable.
- Fit and tighten the cable securing nut to the specified torque figure.
See Figure.
- Adjust, or verify, the cable in accordance with SELECTOR LEVER CABLE ADJUSTMENT .
- Further installation is the reverse of the removal procedure.
- Connect the battery and fit the battery cover.
- Reset the radio and the clock.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
