Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Jaguar XJ8 BaseFACTORY OEM SERVICE PROCEDURE
Speed Control Sensor Adjustment - General Procedures
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 Jaguar XKR, 2009 Jaguar XK8, 2008 Jaguar XKR, 2008 Jaguar XK8, and 2007 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools
| Tool Illustration | Tool Name | Tool Number |
|---|---|---|
| Inclinometer | 501-F007 |
- Raise and support the vehicle.
- Remove the front bumper cover. Refer to Front Bumper Cover .
- Position the vehicle on a smooth level surface and settle the suspension.
- Using the special tool, check the speed sensor is level, (+/- 0.5 degree).
WARNING:
Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
CAUTION:
Drive the vehicle on to a flat, level surface.
NOTE:
The speed sensor has no mechanical horizontal adjustment.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
