2003 Jaguar XJ8 BaseFACTORY OEM SERVICE PROCEDURE

Speed Control Module - Removal and Installation (Vehicles With: Adaptive Speed Control): Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 Jaguar XKR, 2009 Jaguar XK8, 2008 Jaguar XKR, 2008 Jaguar XK8, and 2007 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: This component is mounted to the rear of the RH A-pillar.
GJ0009304Courtesy of JAGUAR CARS, INC.
    NOTE: LH illustration shown, RH is similar.
  1. Remove the RH cowl side trim panel.
    GJ0010443Courtesy of JAGUAR CARS, INC.
  2. Remove the adaptive speed control module.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.