2003 Jaguar XJ8 BaseFACTORY OEM SERVICE PROCEDURE

Visual Inspection Chart

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Jaguar XKR, 2006 Jaguar XK8, 2005 Jaguar XKR, 2005 Jaguar XK8, and 2004 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
Visual Inspection Chart

Mechanical Electrical
  • Engine oil level
  • Cooling system coolant level
  • Fuel level
  • Fuel Contamination/grade/quality
  • Throttle body
  • Poly-vee belt
  • Fuses
  • Wiring harness
  • Electrical connector(s)
  • Controller Area Network circuits
  • Sensor(s)
  • Engine control module (ECM)
  • Transmission control module
  1. Verify the following systems are working correctly:
    • Air intake system
    • Cooling system
    • Charging system
    • Fuel charging system
    • Ignition system
  2. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step
    NOTE: If a DTC cannot be cleared, then there is a permanent fault present that flags again as soon as it is cleared. (The exception to this is P1260, which will only clear following an ignition OFF/ONΒ  cycle after rectification.)
  3. If the cause is not visually evident and the Jaguar approved diagnostic system is not available, use a scan tool to retrieve the fault codes before proceeding to the diagnostic trouble code (DTC) index chart, or the symptom chart if no DTCs are set.
CAUTION: When probing connectors to take measurements in the course of the pinpoint tests, use the adaptor kit, part number 3548-1358-00.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.