Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Speed Control - Description & Operation: Notes
| Item Number | Description |
|---|---|
| 1 | Speed control switch - vehicles with adaptive speed control |
| 2 | Speed control switch - vehicles without adaptive speed control |
| 3 | Speed control module - vehicles with adaptive speed control |
| 4 | Forward alert switch - vehicles with adaptive speed control |
The Speed Control system offers the driver relaxed vehicle cruising by enabling a pre-set constant vehicle speed to be maintained without driver operation of the accelerator pedal.
Speed control switch - vehicles without adaptive speed control
The speed control switch provides for driver increase (SET +) or decrease (-) of set vehicle speed, suspension of system operation with set speed memorized (CANCEL) and resumption of operation at memorized vehicle speed (RESUME). The vehicle speed control system will not operate below 26km/h (16mph).
The set vehicle speed can be increased or decreased in 2km/h (1mph) increments by briefly pressing the (SET +) or (-) control button. Alternatively, the (SET +) or (-) button can be pressed and held until the required vehicle speed is reached.
Automatic switch off - vehicles without adaptive speed control
The speed control will disengage, but not clear the memory when:
- the CANCEL button is activated.
- the brake pedal is applied.
- the vehicle speed falls below 26Km/h (16mph).
- neutral, park or reverse gear positions are selected.
- traction control is activated.
The speed control will disengage, and clear the memory when:
- the ignition switch is set to position '0'.
- maximum vehicle speed is reached.
- the parkbrake is applied.
- a fault occurs in the adaptive speed control system.
Speed control failure - vehicles without adaptive speed control
If a fault occurs during any speed control operation the speed control system will be deactivated and will remain in this state until the fault is rectified. The message center will display 'CRUISE NOT AVAILABLE'.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
