Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Anti-Lock Control: Abs/TCCM
The ABS/TCCM is integrated with the hydraulic control unit. It houses the solenoids that operate the hydraulic control unit's input and return valves; the valve stems locate into the ABS/TCCM's solenoids. There is no electrical connection between the ABS/TCCM and the hydraulic control unit.
The ABS/TCCM constantly monitors the brake electronic system by passing self-checking electrical pulses around the circuit. The self check procedures carried-out by the ABS/TCCM are listed below:
- Monitoring of the operating voltage: the control module will shut-down should the voltages not be (approximately) in the range of 9 to 19V.
- The pump is monitored for voltage supply and voltage feedback.
- Monitoring for disturbance, where a failure may be caused by external radio frequency interference, internal leakage current, defective valve transistor or a faulty valve.
- Internal controller failure, detected by a RAM and ROM test.
- The controller area network (CAN) micro-controller checks for correct operation of the communication network and performs a RAM self-check.
Signals processed by the ABS/TCCM are also sent to the CAN for vehicle use, such as the instrument cluster speed display, cruise control and stability/traction control.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
