Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJAGUAR2002X-TYPE (X400) V6-2.5LREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCONTROL ASSEMBLYSERVICE AND REPAIR
2002 Jaguar X-Type (X400) V6-2.5L
Control Assembly: Service and Repair
2002 Jaguar X-Type (X400) V6-2.5LSECTION Service and Repair
Removal
Vehicles with automatic transaxle
1. NOTE: To aid removal of the climate control assembly place the J-gate selector in the neutral position.
Remove the J-gate surround.
Vehicles with manual transaxle
2. Detach the gear selector surround.
All vehicles
3. Disconnect the battery ground cable. Service and Repair
4. Remove the ashtray retaining screws.
5. Remove the ashtray.
- Disconnect the electrical connectors.
6. Remove the climate control assembly mounting bracket upper retaining screws cover.
7. Remove the climate control assembly mounting bracket upper retaining screws.
8. Remove the climate control assembly mounting bracket lower retaining screws.
9. Disconnect the hazard lamp switch assembly electrical connectors.
10. Remove the hazard lamp switch assembly.
- Remove the retaining screws.
11. Disconnect the climate control assembly electrical connectors.
12. Remove the climate control assembly retaining screws.
13. Remove the climate control assembly.
1. Remove the retaining screws.
2. Remove the climate control assembly.
Installation
1. NOTE: Make sure the climate control assembly is correctly located into the audio unit.
To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.