2001 Jaguar XK8 2D ConvertibleFACTORY OEM SERVICE PROCEDURE

Anti-Lock Brake System (ABS) Module: Installation

  1. Install ABS/TCCM, take care not to damage brake tubes.
    • Install and tighten bolts.
      Fig 1: Installing ABS/TCCM
      G03120781
  2. Install brake tubes.
    • Remove plugs from ports and brake tubes.
    • Install brake tubes and tighten union nuts. Refer to SPECIFICATIONSΒ  for torque setting.
      Fig 2: Installing Brake Tubes
      G03120782
  3. Connect upper electrical connector.
    • Push plunger down to secure connector.
      Fig 3: Connecting Upper Electrical Connector
      G03120783
  4. Install elbow to washer bottle filler neck.
    • Install 'O'-ring seal.
    • Install elbow.
      Fig 4: Installing Elbow To Washer Bottle Filler Neck
      G03120784
  5. Remove special tool from brake pedal.
  6. Reconnect battery ground cable. Refer to BATTERY RECONNECTION PROCEDURE .
  7. Bleed brake system. Refer to BLEEDING PROCEDURE .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.