Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2001 Jaguar XJ8 BaseFACTORY OEM SERVICE PROCEDURE

Anti-Lock Brake System (ABS) Module: Installation

Install the ABS/TCCM to the HCU.
- Install and tighten bolts. (1)
- Connect electrical connector. (2)
Fig 1: Installing ABS/TCCM To HCU
Courtesy of JAGUAR CARS, INC.
Install HCU.
- Taking care not to distort brake tubes position HCU into bracket.
- Install bolts and tighten to 8-10 Nm.
Fig 2: Installing HCU
Courtesy of JAGUAR CARS, INC.

NOTE: To minimize brake fluid loss, install the brake tubes to the HCU in the order shown.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.