2000 Jaguar XJRFACTORY OEM SERVICE PROCEDURE

Navigation System Module - Removal and Installation: Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Jaguar S-Type, 2007 Jaguar S-Type, 2006 Jaguar S-Type, 2005 Jaguar S-Type, and 2004 Jaguar S-Type. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Make sure the navigation CD has been removed before disconnecting the battery ground cable.
  1. Disconnect the battery ground cable. Refer to Battery, Mounting and Cables .
    GJ0003210Courtesy of JAGUAR CARS, INC.
  2. Detach the luggage compartment side trim panel.
    1. Remove the luggage compartment side trim panel retaining clip.
    2. Detach the luggage compartment side trim panel.
    GJ0004655Courtesy of JAGUAR CARS, INC.
  3. Detach the module retaining bracket.
    GJ0004663Courtesy of JAGUAR CARS, INC.
  4. Disconnect the navigation system module electrical connectors and fibre optic connector.
    GJ0004664Courtesy of JAGUAR CARS, INC.
  5. Remove the navigation system module.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.