Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Jaguar XJSFACTORY OEM SERVICE PROCEDURE
Sensor Operating Range Charts
WARNING: This page is about a different car, the 1997 Jaguar XJR. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Unless stated otherwise in test procedure, perform all voltage tests using a Digital Volt-Ohmmeter (DVOM) with a minimum 10-megohm input impedance.
ENGINE COOLANT TEMPERATURE SENSOR RESISTANCE
| Temperature °F (°C) | (1) Ohms | ||
|---|---|---|---|
| 32 (0) | 5000-8000 | ||
| 50 (10) | 3000-5000 | ||
| 68 (20) | 2000-3000 | ||
| 86 (30) | 1500-2000 | ||
| 104 (40) | 1000-1500 | ||
| 122 (50) | 700-1000 | ||
| 140 (60) | 600-800 | ||
| 158 (70) | 300-600 | ||
| 176 (80) | 260-400 | ||
|
|||
EGR TEMPERATURE SENSOR RESISTANCE
| Temperature °F (°C) | (1) Ohms | ||
|---|---|---|---|
| 212 (100) | 60,000-100,000 | ||
| 302 (150) | 15,000-25,000 | ||
| 392 (200) | 3000-8000 | ||
| 482 (250) | 1500-2500 | ||
| 572 (300) | 400-1000 | ||
| 662 (350) | 250-350 | ||
|
|||
HEATED OXYGEN SENSOR VOLTAGE
| Condition | Volts |
|---|---|
| Lean | 0.2 |
| Rich | 4.8 |
INTAKE AIR TEMPERATURE SENSOR RESISTANCE
| Temperature °F (°C) | (1) Ohms | ||
|---|---|---|---|
| 32 (0) | 5000-8000 | ||
| 50 (10) | 3000-5000 | ||
| 68 (20) | 2000-3000 | ||
| 86 (30) | 1500-2000 | ||
| 104 (40) | 1000-1500 | ||
| 122 (50) | 700-1000 | ||
| 140 (60) | 600-800 | ||
| 158 (70) | 300-600 | ||
| 176 (80) | 260-400 | ||
|
|||
MASS AIRFLOW SENSOR VOLTAGE
| Condition | (1) Volts | ||
|---|---|---|---|
| 700 RPM | 1.30 | ||
| 1500 RPM | 1.70 | ||
| 3000 RPM | 2.30 | ||
|
|||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.