1996 Jaguar XJSFACTORY OEM SERVICE PROCEDURE

Service Intervals & Specifications

WARNING: This page is about a different car, the 1997 Jaguar XJ6. However, it is still accessible from the selected car via links, so may be relevant.
REPLACEMENT INTERVALS

Component Interval (Miles)
Air Filter 30,000
Automatic Transmission Fluid & Filter 30,000
Coolant 60,000
Fuel Filter 60,000
Oil & Filter 7500
Oxygen Sensor 52,500
Spark Plugs 30,000
BELT ADJUSTMENT

Application (2) Tension
A/C Belt
New 125-130 (57-59)
Used 85-90 (39-41)
Alternator & Water Pump Belt
New (3) 125-130 (57-59)
Used 115-120 (52-54)
(1) Tension in Lbs. (kg) Using Belt Tension Gauge.
(2) With pressure applied midway on belt run.
(3) Adjust belt to new belt specification. Run engine for one minute. Shut engine off and allow belt to cool. Reset belt to used belt specification.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.